What you need to know to install the roof itself
It always seems a good idea to save money and achieve their renovation projects for themselves, but for something as important as the installation of the roof must be sure to have all the information you need to do the job. Otherwise, save money now could result in spending later in the repair of roofs, so that the options. If you want to produce a slate or tile, or metal complexes, it would be better to spend extra money to hire an expert, but the easiest way for guidelines on the right allows you to ‘ save significant costs on the contractor.
Roll Roofing
This method is cheaper but also easier to install itself, so if you are looking for an immediate choice to replace him or will be in about 8-10 years, this may be the best solution for the short term.
Installation
1. Buy your roof and roller coating panels cut so that the design can be solved
2. Place the first vertical panel on the roof to fall on the edge about 1 / 2 ”
3. Use roofing cement to glue the pieces down and nail with 2 nails every 12 cm.
Rolled roofing is not only low, but a very interesting solution, particularly ideal for roofs that do not see much anyway. A little “wiser, but feasible as a do-it-yourself project, try to shake shingles or tiles.
Cedar, cement, clay or asphalt
Asphalt shingles are another of low-cost solutions that are simple enough for you to install, but if you can choose different colors, which are simple and flat and not very attractive. Shingles or cedar shingles add more style and tone of cement or tiles to give a much higher level of elegance and charm. All are very similar to the installation, however, with slight variations but the basic similarities.
How do I install
1. Concrete or clay, to see to help a first layer of plywood to support the excess weight.
2. Heroes of the base layer in the form of felt paper to absorb moisture.
3. Horizontal bar is assured that the bricks or shingles, which are attached.
4. Start from the bottom left and cross a horizontal line, stuck in the gravel, shake or tile
5. With the top layer, nail in the row so as to cover the base to the table and nails.
This possibility is much more work, but not very complicated, and time will be saved a lot of money in the roof of the factory itself.
